Troubleshooting

Dimming up not possible.

• Reduce/increase load.

• Allow the module to cool in case of overheating.

• Change the load (if the load is incompatible with the module).

Switching on not possible.

• Allow the module to cool in case of overheating.

• Reduce load.

• Change load.

• Check wiring between the push button and the module.

Flickering at minimum brightness.

• Increase minimum brightness (if flickering still persists, install a 31LCDA load correction device).

• Change the load (if the minimum brightness is insufficient).

• Set RL LED mode (it is advised to use 10 % of nominal load to avoid overheating of the module).

Flickering

• Change load.

• Set RL LED mode (it is advised to use 10 % of nominal load to avoid overheating of the module).

Only slight dimming capability

• Change dimming range.

• Set RL LED mode (it is advised to use 10 % of nominal load to avoid overheating of the module).

• Change the load (if the load is incompatible with the module).

The device is not ready to pair after the device is removed from the app.

Reset to factory default settings, refer to Resetting the device manually.