Com’X 200 Device Settings

The Device Settings interface defines the devices connected to the energy server, for example, Ethernet gateways, Modbus meters, pulse meters, or analog sensors.

All devices have General Properties and Monitored Area.

Add downstream devices to your Com’X.

You can modify device settings.

There is a procedure to disconnect a device from an upstream device.

You can reconnect a device from an upstream device.

You can replace an existing device with another device of a similar type.

You can delete devices from the Com’X.

The exported data varies per hosted platform.

Built-in pulse meters have specific measurement properties.

The Com’X supports resistance temperature detectors connected to its analog inputs.

You can add an analog device that is based on a custom analog device model.

With the Modbus discovery function, the Com’X can discover the devices that are locally connected to their Modbus serial port and downstream Modbus TCP/Modbus serial line gateways.

Modbus devices that are not connected cannot be discovered, but they can be added manually using the following procedure.

The Com’X retrieves available measurements from Schneider Electric Modbus meters.

The WT4200 Modbus Receiver is a Modbus interface between the Com’X and the WT4200 radio transmitters.

The Acti 9 Smartlink is a remote I/O module. It transmits data from an Acti 9 System to the Com’X, the EGX100, or the EGX300 through the Modbus serial line communication network.

You can add built-in Ethernet devices to your system.

With the ZigBee discovery function, the Com'X can discover ZigBee devices that are within range.