Uploading a Duplicate Configuration with a USB Key

You can upload a duplicate configuration file from another Com’X using a USB key.

DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH This equipment must only be installed and serviced by qualified personnel. Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E in the USA, CSA Z462 or applicable local standards. Failure to follow these instructions will result in death or serious injury.

Copy the duplicate configuration file to a folder named "Restore" at the root of the USB key.
Power off the Com’X, then plug the USB key into the USB port on the Com’X front panel.
Power on the Com’X, and wait for it to reboot.

When the power LED turns green, the reboot is complete.
Reconnect to the Com’X.
Click Settings > Site Settings > Site Information.
Type the new site location name, then click Save changes to save the modification.

NOTE: The site location name may not include any of the following: '/:*?<>| or space.
Click the Device Settings tab.
Select the Com’X in the Device tree view.
Type the Com’X name in the General Properties collapsible menu.
Click Save changes to save your modification.
Click the Measurement table tab to check the correct connection, setting, and functioning on the new site.
Select Commissioning tab to activate logging and publication according to destination platform.
(see Commissioning for more information)