7EN02-0390-03

Configuring EtherGate using the webpages

You can use the meter webpages to configure EtherGate communications on your meter.
  1. Connect to your meter’s webpages.
  2. Navigate to Setup > Serial Port.
  3. Expand Basic Settings or Advanced Settings and modify the settings for the serial port you are configuring for EtherGate communications (COM1 / RS485#1 or COM4 / RS485#2).
  4. Change the settings, then click Apply. Click Yes to save the changes.
    Parameter Setting

    Protocol

    EtherGate

    Baud Rate

    Serial Port

    Serial port settings must match the settings for all connected serial devices

You can use ION Setup to create an Ethernet gateway site and access the serial network of devices connected through the EtherGate meter.
QR code for this page

Was this helpful?