7EN02-0390-03

Configuring EtherGate using ION Setup

Use ION Setup to configure EtherGate communications on your meter.
  1. Start ION Setup.
  2. Open the Setup Assistant for your meter.
  3. Navigate to Communications > Serial settings.
  4. Select the tab (Com1 or Com4) for the serial port you want to configure.
  5. Highlight the parameter and click Edit. Enter the meter password if prompted, change the setting, then click OK to save the changes.
    Parameter Setting

    Protocol

    EtherGate

    Baud Rate

    Serial Port

    Serial port settings must match the settings for all connected serial devices

  6. Create an Ethernet gateway site to access the serial network of devices through your gateway meter.
QR code for this page

Was this helpful?