Configuring Syslog network settings using ION Setup

You can configure your syslog settings using ION Setup.
  1. Open the Setup Assistant for your meter. See the ION Setup Help for instructions.
  2. Select Communications > Advanced Ethernet and click the SysLog tab.
  3. Select Enable Syslog and click Edit.
  4. Select Yes to enable the syslog server feature or select No to disable it.
  5. Click OK.
  6. Select Syslog Server and click Edit.
  7. Enter the IPv4 address or an IPv6 address for the syslog server.
    NOTE: You must enter the IP address for the syslog server, not the server’s fully-qualified domain name.
  8. Click OK.
  9. Verify that the Syslog server is receiving log information from the meter.
    NOTE: If the Enable Syslog register is enabled but the Syslog Server register does not contain an IP address, an event is generated in the event log to indicate that syslog is enabled with no server IP.
QR code for this page

Was this helpful?