Option I/O modules configuration

You can configure your meter’s I/O option modules using ION Setup.

The Option I/O Modules screen has tabs corresponding to the possible option modules, which are identified based on how the option modules are connected to the meter. Each tab indicates the module’s type and status, and has an area where the module’s ports are listed for viewing and configuration. You can also reset your meter’s option modules using ION Setup.

Status examples Description
None No option module detected
Normal The option module is operating normally
Option module added A new option module is detected
Option module removed The option module has been removed
Invalid S19 The option module’s firmware is not supported
Invalid card The option module type is not supported

QR code for this page

Was this helpful?