Odace - Connected Universal Rotary Dimmer LED – Device user guide PDF
DUG_Odace Rotary Dimmer_WH-03

Pairing Wireless switch with Rotary dimmer

To pair the Wireless switch to the Rotary dimmer, you must put the Wireless switch and the Rotary dimmer into pairing mode.
NOTE: The pairing mode will be active for about a minute.
  1. Remove the rocker of the Wireless switch.

    • Make sure the Wireless switch is aligned correctly to identify the pairing buttons.

      • 1-gang wireless switch: Pairing button (A)

      • 2-gang wireless switch: Pairing button for the right channel (A)

      • 2-gang wireless switch: Pairing button for the left channel (B)

    NOTE: The Wireless switch is configured for 1-gang operation by default. To switch from 1-gang to 2-gang operation, refer to Switching from 1-gang to 2-gang.
  2. Short press the push-button (A) 5 times in quick succession on the Wireless switch.
    The status LED blinks green.

  3. Short press the push button of the Rotary dimmer 5 times in quick succession.
    The status LED blinks green.

    The light connected to the Rotary dimmer blinks for a few times. The status LED stops blinking green on the Wireless switch and the Rotary dimmer. The Rotary dimmer can now be controlled by the Wireless switch.

  4. Assemble the rocker (A) and rotary knob (B) on the Wireless switch (A) and the Rotary dimmer (B), respectively.
    A B
QR Code is a registered trademark of DENSO WAVE INCORPORATED in Japan and other countries.

Was this helpful?

Contact Information
Legal Information
Privacy Policy
Change your cookie settings