DUG_PowerTag-E_WH-07

Configuring - flat rate

To set flat rate:
  1. After reading the Tariff onboarding information. On the Tariff screen, tap Electricity.
    NOTE: If you have already configured your tariff settings, follow below menu navigation if you need to modify tariff rate.
    On the Home page, tap > Energy Management > Tariff > Electricity.
  2. Tap (A) and select Flat.
    IMPORTANT:
    • Contract limit is already set when pairing the main PowerTag as Grid. Refer to Pairing the main device.

    • If you like to change the contract limit, proceed to step 3.

  3. Tap (B) to set the contract limit.
    The Contract Limit page appears.
    1. Select your contract limit (kVA/A/kW) from the dropdown menu, then tap and enter a value using the dial pad as per your country.

      A notification window will be prompted that the Contract Limit is used by Anti-Tripping Management algorithm. If set incorrectly it may not work as expected and could result in the power tripping.

      IMPORTANT: Anti-Tripping is applicable only if you have installed Water Heater/EV Socket/Schneider Charge/EVlink Home Smart in your home.
      For more details, refer to Anti-Tripping (Add Link).

    2. Tap Continue, if you like to proceed.
  4. Tap (C) and select a subscription type (D) (refers to recurrent fee).
  5. Enter a value in the Cost (€) (E) field and tap Set.
  6. Tap (F), enter a flat rate of consumption in the Rate - €/kWh field and tap Update.
  7. Tap Save (G).
QR Code is a registered trademark of DENSO WAVE INCORPORATED in Japan and other countries.

Was this helpful?