Search Results: Away Mode

Silencing the device Silencing the device Silencing the device Hush the smoke alarms During an alarm event, first identify the smoke alarm/s that detected smoke, these will have Red LEDs blinking. Then short press the Test/Hush button on the device to stop the alarm. In hush mode, the device will

Silencing the device Silencing the device Silencing the device Hush the smoke alarms During an alarm event, first identify the smoke alarm/s that detected smoke, these will have Red LEDs blinking. Then short press the Test/Hush button on the device to stop the alarm. In hush mode, the device will

button 3 times, the device LED blinks red/green for 30 s. Pairing mode has changed to Bluetooth mode. Press the top-right push button on the device 3 times then hold for 20 s, until the LED blinks red. The device should reboot into the correct mode (Zigbee mode).

: In the “ clockwise” direction to increase the temperature. In the “ anti-clockwise” direction to decrease the temperature. When the system is in heating mode and the setpoint is higher than the current room temperature then the demand LED is lit Red to show the heating mode is active. When the system is in cooling mode and the setpoint is lower than the current room temperature then the demand LED is lit Blue to show cooling mode is active.

system is in cooling mode in a non-cooling room: The Radiator Thermostat shall not perform a Boost and shall display the same status as in Device Lock mode. The Room thermostat shall wake up using any of the 3 keys (+, -, O), but subsequent button presses will not change the set point. Domestic

(A) to adjust the set-point temperature (Heating). The current operating mode indicates the mode in which the system is working. Off : Turns the system off, available in Home screen. Heating : System operates in heating mode when the set-point temp > room temp. Boost mode : Boost Mode will apply a

du commutateur sans fil. Le dispositif ne peut pas se connecter au concentrateur. Après avoir appuyé 3 fois sur le bouton-poussoir supérieur droit, la LED de l’appareil clignote en rouge/vert pendant 30 s. Le mode d'appariement est passé en mode Bluetooth. Appuyez 3 fois sur le bouton-poussoir

Changing the device from 1-gang to 2-gang Changing the device from 1-gang to 2-gang Changing the device from 1-gang to 2-gang You can change the Wireless switch mode from 1-gang to 2-gang before you pair your device to the Hub/Gateway. The Wireless switch is in 1-gang mode by default. Follow the

. Reduce load. Change load. Check wiring between the push button and the Puck. Flickering at minimum brightness. Increase minimum brightness (if flickering still persists, install a 31LCDA load correction device). Change the load (if the minimum brightness is insufficient). Set RL LED mode (it is advised

thermostat, appuyez sur le bouton « + » pour augmenter la température. Sur le thermostat, appuyez sur le bouton « - » pour diminuer la température. Lorsque le système est en mode de chauffage et que la valeur de consigne est supérieure à la température ambiante actuelle, la LED de demande est allumée en