Example of an automation
This demonstration shows you how to create an automation
to open the shutter when the room is warm.
- Go to Automation > + to create an automation.
-
Tap Edit name
, enter the name of the automation
and tap Save.
TIP: You can choose the cover image that represents your automation by tapping.
- Tap Add Condition > When device status changes > Temperature Humidity Sensor.
-
Tap Current temperature, set the
temperature and condition and tap Next.
TIP: You can set the temperature as 27 °C and the condition as > (greater than).NOTE: The automation is triggered only if the status of the Sensor changes to a higher temperature than the set temperature. In this case, the automation is triggered when the temperature changes from 27 °C to 28 °C.
-
Tap
to add another condition and tap When device status changes > Temperature Humidity
Sensor.
-
Tap Current humidity, set the humidity
and condition and tap Next.
TIP: You can set the humidity as 65% and the condition as > (greater than).NOTE: The automation is triggered only if the status of the Sensor changes to a higher humidity than the set humidity. In this case, the automation is triggered when the humidity changes from 65% to 66%.
- Tap Add task > Run the device > Shutter.
- Tap Control (A), select Shutter Open and tap Save.
- Tap Percentage (B), set the shutter open percentage and tap Save.
-
Tap Next.
-
In the Automation Settings page,
tap Save.
Once the automation is saved, it is visible on the Automation tab. You can tap the toggle switch on the automation to enable it.