Pairing device manually - Clipsal Portal

On Home page, tap + .

Tap

and select the Wiser Hub

Select an option to add the device (A):

TIP: It is recommended to add the device with install code.

To pair the device with an install code, tap Add Device with Install Code to display the slide-up menu. Select any one of the options (B):

Scan Install Code: you can scan the device for the install code.
TIP: You can find the QR code on the rear side of the device.
Enter Install Code Manually: you can manually enter the install code from the device.
TIP: You can find the install code on the rear side of the device.

After scanning or entering the install code, proceed to Step 6.

To pair the device without install code, tap Add Device without Install Code.

Remove front panel from switch to access the device if you place the module behind a mechanical push button.

Short press the push button 3 times.

The LED blinks orange.

NOTE: If the module is located behind the push button, the status LED is not visible.

In the app, select Confirm LED is flashing orange and tap Start Configuration (C).

After a few seconds, a solid green LED indicates that the device is successfully paired to the Hub.

After the device is added in the app, tap Done.