990–5939–001

Install and Connect the Batteries

NOTE: The illustrations in this procedure show a bottom cable entry system. The procedure is the same for a top cable entry system.
  1. Place the batteries on the shelves in the empty classic battery cabinet and interconnect the batteries.
    NOTE: Do not cover the holes in the shelf corners that are intended for cable routing between the shelves.

    Front View of the Empty Classic Battery Cabinet

  2. Connect the battery cables (Batt+, N, Batt-) from the batteries in the empty classic battery cabinet to the battery breaker.

    Front View of Empty Classic Battery Cabinet

  3. Install the protection cover over the terminals on the right side of the battery breaker.
  4. Note down the battery configuration on the label in the empty classic battery cabinet.
QR Code is a registered trademark of DENSO WAVE INCORPORATED in Japan and other countries.

Was this helpful?