Two-step upgrade using ION Setup

  1. Start ION Setup.
  2. Open the Setup Assistant for your meter.
  3. Select Template > Upgrade tab then click Upgrade. Enter your meter’s password if prompted and click OK.
  4. Navigate to where you have stored the display firmware upgrade file and select Remote Display (.BIN) as the file type.
  5. Select the rmdupg_rd96s_001.000.000_patch.bin firmware file and click Open.
  6. Click Yes to confirm the firmware upgrade. An ION Setup dialog box displays the upgrade progress.
    NOTE: An elapsed timeout is set to 7 minutes.

    An ION Setup summary screen is displayed when the PM89RD96 display rmdupg_rd96s_001.000.000_patch.bin upgrade is complete.

  7. Click Exit.
  8. Repeat steps 4 to 7 using the rmdupg_rd96_004.000.010.bin upgrade file.
    NOTE: An elapsed timeout is set to 7 minutes.
  9. Refer to “Upgrade status” to confirm the display firmware upgrade was completed.

    Contact Technical Support if the display upgrade status indicates Upgrade not completed.

QR code for this page

Was this helpful?