Pairing device manually
To pair the device manually:
- On Home page, tap +.
-
Tap
and select the Wiser Hub on the slide-up menu.
-
Select an option to add the device (A):
- Add Device with Install Code
- Add Device without Install Code
_0001089320.svg)
TIP: It is recommended to add the device with install code. -
To pair the device with install code, tap Add
Device with Install Code to display the slide-up menu.
Select any one of the options (B):
-
Scan Install Code: you can scan the
device for the install code.
TIP: You can find the QR code on the rear side of the device.
-
Enter Install Code Manually: you can
manually enter the install code from the device.
TIP: You can find the install code on the rear side of the device.
After scanning or entering the install code, proceed to Step 6._0001089319.svg)
-
Scan Install Code: you can scan the
device for the install code.
- To pair the device without install code, tap Add Device without Install Code.
-
Short press the push
button 3 times.
The LED blinks orange.NOTE: If the module is located behind the push button, the status LED is not visible. -
In the app, select Confirm LED is flashing orange and tap Start configuration (C).
_0001120455.svg)
After a few seconds, a solid green LED indicates that the device is successfully paired to the Hub. - Once the device is added in the app, tap Done.