Pairing the device with the Wiser Hub
- On the Home screen, tap
. - Tap Devices
and tap Shutters > .TIP: You can also navigate by tapping Control tab > > Shutters > Micromodule Switch.NOTE: The next screen shows the joining process of Puck. - Tap Scan QR code and allow the Wiser
Home app to access your camera. Then, scan the QR code located on
the puck.NOTE: If you are unable to find the correct QR code, tap I can't find the correct QR code to pair the puck manually and proceed to step 4.
If the QR code is incorrect, a message Incorrect QR code scanned will appear. Tap I can't scan the QR code and choose one of the following options:
-
(A): Enter the Mac Address/EUI-64 and Install Code, then tap Connect. The app will verify if the Mac Address/EUI–64 and Install code are valid.
-
(B): Tap this option if you are unable to find the Mac Address/EUI–64 and Install code.
-
- Tap Next and select any one of the
options to add the puck:
- Short press the setup/reset button 3 times on the Puck with a screwdriver and make sure the LED blinks amber.
- Short press the push button 3 times.
NOTE: If the puck is located behind the push button, the status LED is not visible.
Wait for a few seconds until the LED turns green and the app confirms that the device is joined._DD00544794.svg)
- Tap ,
to enter the name of the puck. - Tap Next and assign the puck to
a new room or an existing room and tap Submit.IMPORTANT: The next screen shows the Device Settings page, where you have the option to configure the settings during the pairing process or at a later time. If you prefer to configure it later, tap Submit. For more information on device settings, Configuring the device refer to section.
After you pair the device, a success screen appears with the following options:
-
+ Add New Device: Tap to continue pairing more devices.
-
Start Using Your Device: Tap to start using the paired device.
NOTE: The success screen appears only if you are logged in as a Home Owner. -