Creating an automation
The following is an example of creating an automation to
start the EV Socket and other devices at a specified time.
To create an automation:
- On the Home page, tap
Automation 
. - Tap
and choose an icon that best
represents your automation. - Enter a name of the automation (A) and select any of the
following conditions to meet (B).
- All conditions: All conditions must be met to trigger an automation.
- Any condition: Any one of the condition must be met to trigger an automation.
- Tap Add conditions (C) and select
any of the following (D):
- Device status change (Select the device)
- Away Mode (Enable or Disable)
NOTE: Maximum 10 conditions can be added._0001147872.svg)
_0001130131.svg)
- Select a device (E) that will set the condition.
_0001147335.svg)
- Tap the device icon state (On/Off) to set an action and
tap Set.
_0001147334.svg)
NOTE: To remove an added condition, swipe left and tap
. Then add a new condition with the required parameters. - To add an action, tap and select any
of the following. In this case, Control a device (F).
- Control a device: Select a device that you want to trigger.
- Send notification: Turn on the notification for the automation.
- Activate a moment: Select the moment that you want to trigger.
-
Wait: This option allows you to add a delay in an automation sequence. You can set the wait time in increments of 1 hour and 1 minute, up to a maximum of 24 hours. This feature is useful for delaying actions within an automation.
NOTE:-
Maximum 10 actions can be added.
-
You can add one action in an automation to add another action, you must create another automation.
_0001147333.svg)
- Tap the device (G) to set an action and tap Set.
- TapSave (H).
_0001147332.svg)
_0001147331.svg)
The saved Automation is displayed on theAutomationpage. Tap thetoggle switch to enable/disable the Automation.