DUG_Push-button Module, 1-gang/2-gang_WH-04


Using the Wiser Home app, you can rename the 1-gang switch, edit or assign a new location, identify, and delete the 1-gang switch from the system.
NOTE: Configuring the device shown is for a 1-gang switch, and the same can be done for a 2-gang switch.
  1. On the Home page, tap .
  2. Tap Devices > Lights > 1-gang to locate to the Device Details screen.


    Device Name: Tap to change the name of the device.


    Location: Tap to assign the Device to any room (such as living room, bedroom, kitchen etc). Refer to Setting the device location for more details on how to set the location.


    LED Indicator Behaviour: Tap to set the LED indicator behaviour of the device as per your preference. Refer to Setting up the LED Indicator Behaviour for detailed information on each options.


    Identify: Tap to identify the device.

    • This feature flashes the 1-gang switch LED, so you can identify the actual device. It also switches connected loads on/off.

    • The 1-gang switch LED will continue to flash until you tap OK.


    Delete: Tap to remove the device from the system.


    Zigbee Signal Strength Indicator: Zigbee Signal Strength indicator which displays the current signal strength of the device.

    • Good Signal (between 0 & -54dBm)

    • Normal Signal (between -54 & -79dBm)

    • Poor Signal (<-79dBm)

    • No Signal (device is offline)

QR Code is a registered trademark of DENSO WAVE INCORPORATED in Japan and other countries.

Was this helpful?