Example of an automation
This demonstration shows you how to create an automation
to turn on the Heating to 20 °C when the temperature is less
than 18 °C.
NOTE: It is mandatory to create two automations.
First, switch on the heater at 22 °C when the room temperature
is at 17 °C or lower. Second, switch off the heater when the
room temperature is at 25 °C or above.
The room heater will not turn off automatically until you create another automation.
The room heater will not turn off automatically until you create another automation.
- Go to Automation >
to create an automation. - To add a condition, tap Add Condition > Device status change > Temperature/Humidity Sensor > Temperature.
- Set the temperature as 18 °C (A) and the condition
as less than (B) and tap Set.
_DD00548975.svg)
- Read the information and tap OK.
- To add an action, tap Then > Add an action > Control a device > Heating > Setpoint. Set the temperature to 20 °C (C), then tap Set.
_DD00548974.svg)
- Read the information and tap OK.
- Enter the name of the automation. TIP: You can choose the cover image that represents your automation by tapping
. - Tap Save.
Once the automation is saved, it is visible on the Automation tab._DD00548973.svg)
NOTE: You can enable or disable saved automations on the Automations tab by using
(D).