Creating an automation

The following is an example of creating an automation to turn off the Water Heater when it exceeds the power limit.

NOTE: This automation example is applicable only for users with PowerTag and module installed together.

To create an automation:

On the Home screen, tap > Automation > .
Tap and choose an icon that best represents your automation.
Enter a name of the automation (A) and select any of the following conditions to meet (B).
- All conditions: All conditions must be met to trigger an automation
- Any condition: Any one of the condition must be met to trigger an automation.
Tap Add conditions (C) and select any of the following (D):
- Device status change (Select the device)
- Away Mode (Enable or Disable)
NOTE: Maximum 10 conditions can be added.
Select a device (E) that will set the condition and then select Instant power (F).
Tap more than (G), enter a power value in the field (H) and tap Set.
NOTE: To remove an added condition, swipe left and tap .
To add an action, tap Then > Add an action and select any of the following (I):

NOTE: Maximum 10 actions can be added.
- Control a device: Select a device that you want to trigger.
- Send notification: Turn on the notification for the automation.
- Activate a moment: Select the moment that you want to trigger.
- Wait: This option allows you to add a delay in an automation sequence. You can set the wait time in increments of 1 hour and 1 minute, up to a maximum of 24 hours. This feature is useful for delaying actions within an automation.
Tap Control a device > Water Heater, then tap to turn ON/OFF.

NOTE: By default, the state is set to Off.
Tap Set and then tap Save.
The saved Automation is displayed on the Automation page. Tap the toggle switch to enable/disable the Automation.