Disconnecting a secondary device
Remove a Secondary device
from the mounting base (See "Removing a device from the mounting base”
in the instruction manual).
NOTE:
-
Do not remove the Primary device.
-
Read the following steps before disconnecting a Secondary device.
- Make sure that the power switch is in OFF/AUTO position.
- Press and hold the Test/Hush button and simultaneously
turn the power switch to ON position.
The Standby LED turns on for 3 s. - Continue to hold the Test/Hush button until the Standby
LED turns off. Then release the Test/Hush button.
- Short press the Test/Hush button when the Standby LED is
again on for 3 s.
The Standby LED blinks for 5 s indicating disconnecting of RF interconnection and then the Status LED blinks green for 7 times.IMPORTANT:-
When the Secondary device is successfully disconnected, make sure to turn the power switch to OFF/ AUTO position.
-
Conduct an interconnection test on all remaining smoke alarms when disconnecting is done. Refer, testing the interconnected device(s).
-