Setting the room temperature using the app

Heating

1. On the Control tab, tap All devices or a room tab where the thermostat is located.

2. Tap to select the thermostat.

3. Adjust the room temperature using the slider control for heating:

   Thermostat functions:

   • : Room temperature is below the set point, so the heating is turned on.

   • : Room temperature is above the set point, so the heating is turned off.

   TIP: You can also adjust the set-point temperature:

   • By tapping or in the heating section on the Control tab.

   • By adding the thermostat to your Favourites. To know more about Favourites, refer to the Managing Favorites topic in the respective System User Guide.

   TIP: Tapping you can set the boost time and later it turns off when the boost time ends.
   
   
   
   IMPORTANT:

   • When the boost time is set, the system automatically increases the set-point temperature by 2 °C for the duration of the boost. Once the boost period ends, the temperature returns to the last set-point.

   • Moving the slider control to the bottom of the bar activates Frost Protection mode. In this mode, the system maintains the room temperature at a constant 5 °C to prevent freezing.
     

   

Cooling

1. On the Control tab, tap All devices or a room tab where the thermostat is located.

2. To select a thermostat, tap .

3. Use the slider control and set the room temperature for cooling.

   NOTE:

   • The indicates that the room temperature is higher than the desired temperature (set point), so the cooling is on.

   • The indicates that the room temperature is lower than desired temperature (set point), so the cooling is off.

   TIP: You can also adjust the set-point temperature:

   • By tapping or of the cooling section on the Control tab.

   • When you add it to your Favourites. To know more about Favourites, refer to the Managing Favorites topic in the respective System User Guide.

   TIP: You can initiate boost on & off anytime tapping .
   
   IMPORTANT: Once the boost time is set, the set-point temperature automatically decreases by 2° C for the set boost time. After the boost time is over, the set-point temperature returns to the current scheduled event or to the previous set-point temperature.