DOCA0142EN-08

Schematics with MasterPact MTZ Circuit Breakers

Description

FYI, this map is shared by IFE user guide and MTZ Modbus guide.

The IFE interface is connected to the MasterPact MTZ circuit breaker through its ULP port module.

For more information, refer to the ULP System User Guides .

ULP Connection

NOTICE
HAZARD OF EQUIPMENT DAMAGE
  • Never connect an Ethernet device to a RJ45 ULP port.
  • The RJ45 ULP ports of IFE interface are for ULP modules only.
  • Any other use can damage the IFE interface or the device connected to the IFE interface.
  • To check if a ULP module is compatible with the RJ45 ULP ports of IFE interface, refer to the ULP System User Guides.
Failure to follow these instructions can result in equipment damage.

All the connection configurations require the RJ45 male/male ULP cord.

When the second RJ45 ULP port is not used, it must be closed with an ULP line termination.

A

RJ45 male/male ULP cord

B

ULP line termination

Connection of the IFE Interface to a MasterPact MTZ Circuit Breaker

Connect the IFE interface to the ULP port module on a MasterPact MTZ circuit breaker by using the ULP cord.

A

IFE Ethernet interface for one circuit breaker

B

ULP line termination

C

RJ45 male/male ULP cord

D

ULP port module

E

MasterPact MTZ fixed circuit breaker

QR code for this page

Was this helpful?