Initial Local Connection to the Webmanager

First login with default IP address:

1. Check that the webmanager slide switch is in the left position.

2. Connect your workstation to the webmanagers LAN port with an Ethernet cable, directly or through a switch.

   

3. On your workstation run Command Prompt as administrator.

4. In the Command Prompt window type route add 10.10.10.10 xxx.xxx.xxx.xxx, where xxx.xxx.xxx.xxx is the local IP of your workstation.

5. Press Enter. A success confirmation will be shown in the Command Prompt window.

6. Open a web browser from your workstation.

7. Enter https://10.10.10.10 in the browser address field. A login window will open.

   

8. In the login window enter:

   • User: admin
   • Password: cs141-snmp
   NOTE: After the first log in the user is prompted and required to set a new password.

9. The first login will run the System Setup Wizard that will help you setup the basic configurations of the webmanager.

   NOTE: If the System Setup Wizard does not start automatically on the first login you can launch it by clicking System > Wizard