Mounting
Before installing the device, check the following:
-
The mounting plate must have a thickness of between 0.8 (0.03) and 3.2 (0.13) mm (in).
-
A rectangle measuring 148 (5.83) x 112 (4.41) mm (in) must be cut out from the plate so the device can be installed.
-
No terminal blocks may be connected to the unit.
- Insert the device in the cut-out in the mounting plate by tilting the device forward slightly.
- Depending on the thickness of the mounting plate, clip the spring clips into the mounting slots on the top of the device as follows:
- Clip the 2 spring clips on the side of the device and the 2 spring clips on the bottom of the device.
- Do the wiring and insert the terminal blocks as shown in the relevant wiring diagram (See Wiring diagram).