EAV15107-EN06

Ethernet port setup

The meter is factory-configured with default Ethernet communications settings.

You must modify the default Ethernet settings before connecting the meter to your local area network (LAN).

The default Ethernet communications settings are:

  • IP address = 169.254.0.10

  • Subnet mask = 255.255.0.0

  • Gateway = 0.0.0.0

  • Device name = PM53-#xxxxxxxxxx, where xxxxxxxxxx is the meter’s factory serial number (with leading zeros if serial number is less than 10 characters)

  • IP method = Default

NOTE: Your meter’s serial communications port ID (Com1 ID) is used in both Ethernet and serial communications; you need to change the Com1 ID meter property in ION Setup if you modify the meter’s RS-485 address.

QR code for this page

Was this helpful?