About the Book
Document Scope
The purpose of this guide is to provide users, installers and maintenance personnel with the technical information necessary to install and use the EcoStruxure™ I/O Smart Link module.
Validity Note
The I/O Smart Link module can be easily integrated into any building management architecture.
It combines command and control, metering and protection functions designed for energy efficiency solutions in any type of environment. Based on the Modbus protocol, the I/O Smart Link module allows switchboard data to be exchanged in real time with a supervision system or a PLC.
The pre-wired connector system increases efficiency and helps to prevent wiring errors during installation.
This guide applies to I/O Smart Link with minimum firmware version 003.003.004. For legacy Acti9 Smartlink product with firmware version 001.003.007 or lower, refer to Related Documents.
Online Information
The information contained in this guide is likely to be updated at any time. Schneider Electric strongly recommends that you have the most recent and up-to-date version available on www.se.com/ww/en/download.
The technical characteristics of the devices described in this guide also appear online. To access the information online, go to the Schneider Electric home page at www.se.com.
Related Documents
| Title of documentation | Reference number |
|---|---|
|
I/O Smart Link - Firmware Release Notes |
|
| I/O Smart Link - Instruction Sheet | |
|
iACT24 - Auxiliary on the iCT Contactor - Instruction Sheet |
|
|
iATL24 - Auxiliary on the iTL Remote Control Switch - Instruction Sheet |
|
|
RCA iC60 - Remote Control Auxiliary - Instruction Sheet |
|
|
Reflex iC60 - Integrated Remote Control Circuit Breaker - Instruction Sheet |
|
|
RCA iC60 Remote Control for iC60 Circuit Breakers - Reference Manual |
|
|
Reflex iC60 Integrated Control Circuit Breaker for iC60 Circuit Breakers - Reference Manual |
|
|
Acti9 Smartlink Modbus Communication System - User Manual |
You can download these technical publications and other technical information from our website at www.se.com/ww/en/download/.
Information on Non-Inclusive or Insensitive Terminology
As a responsible, inclusive company, Schneider Electric is constantly updating its communications and products that contain non-inclusive or insensitive terminology. However, despite these efforts, our content may still contain terms that are deemed inappropriate by some customers.
Trademarks
QR Code is a registered trademark of DENSO WAVE INCORPORATED in Japan and other countries.