DIN Ethernet EM3570 series – User manual PDF
7EN02-0443-00

Configuring the display passcode

NOTICE
LOSS OF ACCESS
Record your device's user and passcode information in a secure location.
Failure to follow these instructions can result in data loss and loss of access to the device.

NOTICE
loss of data or product configuration
Do not let unauthorized personnel gain physical access to the device.
Failure to follow these instructions can result in data loss and loss of access to the device.

  1. Press and hold and at the same time for 2 seconds.
  2. Use the or button to enter the meter Passcode (High) (Default is “0010”) and press .
  3. Use the button to scroll to Code and press .
  4. Select Low or use the button to select High and press button to edit the passcode.
  5. Use the or button to modify the selected digit.
  6. Press to confirm the new value and to shift to the next digit. Modify the next digit, if needed, or press .
  7. Continue to move through the digits until you reach the last digit then press again to confirm the new setting.
    If you enter an invalid setting and press cursor stays in the field until you enter a valid value.

    Setting

    Options

    Description

    Low

    0 to 9999

    Set the low passcode for accessing the alarms and resets.

    High

    10 to 9999

    Set the high passcode for accessing the setup and clock.
QR Code is a registered trademark of DENSO WAVE INCORPORATED in Japan and other countries.

Was this helpful?

Contact Information
Legal Information
Privacy Policy
Change your cookie settings