Configuring the multi-tariff
Configure the parameters for command mode and input mode
using the Multi-Tariff screen.
- Double-click on Multi-Tariff to open the dialog setup.
- Select the Tariff Mode and click Edit to open its specific setup dialog.
- Select a tariff mode parameter from the drop down list.
Parameters
Options
Description
Tariff Mode
Disabled (Default)
Disable the tariff mode selection.
Tariff mode selections are as per the below table:
From
To
Disabled
Comm mode, 1 S In mode and 2 S In mode
Comm mode
Disabled
1 S In mode
2 S In mode
2 S In mode
1 S In mode
RTC mode
Comm mode
COM Mode
The tariff is controlled by communication. In the communication control mode, the tariff switching is triggered by a command.
1 SI Mode
Select the status input 1 mode.
NOTE: The status input 1 mode in the I/O setup changes to tariff control when the tariff mode is set to status input (1 SI Mode).2 SI Mode
Select the status input 2 mode.
NOTE: The status input 2 mode in the I/O setup changes to tariff control when the tariff mode is set to status input (2 SI Mode). - Click OK, and then click Send to save your changes to the meter.NOTE: When changes are not saved to the meter, the status bar on the bottom left screen shows Download Incomplete.