EM3570 series configuration screens

Configure the Data Log 01 to Data Log 16 parameters using the Data Logging screen.

Configure the status inputs and relay output parameters using the I/O Setup screen.

Configure the various input channels for the meter using the Input Metering screen.

Configure the values for the LED mode parameters using the LED Pulsing screen.

Configure the suppression current using the Advanced Setup screen.

Configure the alarm parameters using the Alarming screen.

Configure the power system type, CT and VT ratio, nominal frequency, and phase rotation using the Basic Setup screen.

Configure the date and time of the internal clock of a device and synchronize the date and time of the devices in your system with your workstation using the Clock screen.

Configure the power demand parameters using the Demand Setup screen.

Configure the HMI setup time out period and IEC/IEEE standard selection using the Front Panel Display screen.

Reset all the energy, peak demand and I/O counters (status input counters, relay counters, and input metering counters) using the Meter Resets screen.

Configure the parameters for command mode and input mode using the Multi-Tariff screen.

Generate reports for the current meter configuration using the Reports screen. You can use this screen to view, print, and save a report file, which serves as a record of the meter's current configuration.

The ION setup supports real-time data display for your meter.

You can view the communication status, meter model number, firmware version, serial number and Modbus tester interface troubleshooting wizard using the Diagnostics screen.