Transport of the Cubicle with Crane

CAUTION

hazard of equipment damage Please make sure to utilize the lifting bracket when handling the MCSeT switchgear and ensure that lifting bracket is properly secured with fasteners. Adhere to the specified height for lifting and follow the recommended lifting procedures. Refrain swing area of the cubicle when lowering or raising it into position. Failure to follow these instructions can result in injury or equipment damage.

Follow the below steps to transport the cubicles using crane:

1. Attach four crane ropes/chains (observe minimum carrying capacity and length). Lift the cubicle carefully.

   NOTE:

   • Lifting cables must be secured firmly before lifting. Good practices of the lifting must be followed.

2. Release the screw-fastenings between the lateral fixing brackets (1) on the pallet (2) and the cubicle.

3. Place the cubicle carefully on the floor at the intended site of installation.

Figure 11
Switchgear Cubicle Transport with Crane