Access Management Per Access Path

Data on MicroLogic Active control units can be accessed:

From the MicroLogic Active HMI (PIN code protected)
On a device connected to the MicroLogic Active USB-C port (password protected):
- An Android smartphone running EcoStruxure Power Device app through USB OTG connection
- A PC running EcoStruxure Power Commission software
On remote controllers through the ULP modules of the IMU system (only if the MicroLogic Active control unit is in Auto Remote control mode)
On a smartphone running EcoStruxure Power Device app through NFC connection
On Panel Server webpages and on servers or remote controllers connected to Panel Server, through Zigbee wireless communication (MicroLogic Active AP/EP control unit only)

The following table describes the functions which can be accessed via each access path, and the required protection mechanisms (if any).

Function	Description	Access path
Function	Description	HMI	USB port	IMU	Zigbee	NFC
Monitoring	Read settings, measurements, and data	✔	-	✔	✔	✔
Settings	Set MicroLogic Active control unit settings	✔ (1)	✔ (2)	-	-	-
Reset counters	Reset minimum and maximum values	✔	-	-	-	-
Test	Send test commands	✔ (1)	-	-	-	-
Firmware update	Update firmware to the latest version	-	✔ (2)	-	-	-
Operation	Send commands to open and close the circuit breaker	-	-	✔ (3)	-	-
MicroLogic Active replacement	Set the settings of a replacement MicroLogic Active control unit	✔ (1)	-	-	-	-
✔ Access allowed without restriction ✔ (1) Access protected by PIN code ✔ (2) Access protected by USB password ✔ (3) Access only allowed in Auto Remote control mode