Hotkeys - ArcFM Solution Documentation Portal

Map

Map
CU search	Ctrl+F
Save Design	Ctrl+S
Redo	Ctrl+Y
Undo	Ctrl+Z
Zoom In	Ctrl++
Zoom Out	Ctrl+-
Go Back Extent	Alt+LeftArrow
Go Forward Extent	Alt+RightArrow
Deletes Selected Component, CU, or Map Notation	Delete
Cycle through Design Styles	Ctrl+Shift+S

Design Tab
Select	Alt+S
Select by Rectangle	Alt+R
Place Transformer	Alt+X
Place Conductor	Alt+C
Place Conduit	Alt+O
Place Pole	Alt+E
Place Span Guy	Alt+J
Place Surface Structure	Alt+Z
Place Fuse	Alt+F
Place Recloser	Alt+B
Place Switch	Alt+I
Place Service Drop	Alt+V
Place Electric Network Component	Alt+G
Place Generic Line Component	Alt+L
Place Work Location	Alt+W
Replace	Alt+Ctrl+F
Trace	Alt+T
Measure	Alt+M
Place Cut Point	Alt+Y
Address Search	Alt+A
Update Catalog	Alt+U
Switch to Print Tab	Alt+P
Switch to Design Tab	Alt+D
Run Auto-Assign Work Location	Alt+K
Copy current XY location to clipboard	Ctrl+L
Toggle display between projected XY and latitude/longitude	Ctrl+Alt+L
Cycle Through Label Styles when Using the Move Label Tool	A to cycle forward through styles Z to cycle backward through styles

Design Tab Tool Modifiers
Disable Snapping	Spacebar
Lock in Preferred Transformer when using Place Service Drop	Ctrl
TIP: The Place Service Drop tool automatically snaps the service line to the nearest transformer. To temporarily override this functionality (in order to “lock in” a preferred transformer that might not be the closest in proximity), first allow the tool to find and snap to your preferred transformer. Then, hold Ctrl while moving the service meter into position. This keeps you snapped to the preferred transformer, even if other transformers are nearby. If your service line is straight (no bends), double-click to finish the sketch. If your service line has bends in it, each click adds a bend. After you add your first bend, you can release Ctrl. Double-click to finish the sketch. For more information, read the topic Place Service Drops.
Finish Linear Sketch	Enter
Finish Linear Sketch	Double Click
Cancel Selected Tool/Action	Esc
Pan map when in Remove Brush tool mode	Ctrl+Drag

Place Service Drop Tool Modifiers
Lock to nearest Service Drop tap	Ctrl (or after first click)
Disconnect Service Point from Service Drop	Shift
Place Service Point in Space	Shift+Click

Sketching Templates
Rotate Template Counter-Clockwise	<
Rotate Template Clockwise	>
Flip Template Vertically	n
Flip Template Horizontally	m
Lock Template Angle after Rotating (stops nearby lines from overriding your set angle)	Spacebar (press once, do not hold; press once again to unlock)
Enlarge Template (you can enlarge a template to about twice its originally-drawn size)	+
Shrink Template (you can shrink a template to about half its originally-drawn size)	-

Removes
Accept Removal CU when Green Hover is Up	A
Select a Removal CU when Red Hover is Up	C

Print Tab
Delete selected elements (this hotkey does not delete maps; to delete a map, select it, then click the Delete tool on the toolbar)	Delete
Pan on Print Layout page when zoomed in	Press and hold the Mouse Wheel, then Drag
Pan the map	Press and hold the Arrow Key in the desired direction
Change the zoom of the map	Roll the Mouse Wheel
Change the zoom of the map just a little	Ctrl + Roll the Mouse Wheel
Cycle Through Label Styles when Using the Move Label Tool	A to cycle forward through styles Z to cycle backward through styles

Project Pane
Delete Selected Component or CU	Delete