Remove a Single Component
- On the map, select the component to remove.
-
Right-click the component, then select Remove.
After clicking Remove, there are three possible outcomes:
-
Designer XI successfully locates and assigns the appropriate removal CU.
-
The component on the map takes on the removal color of green.
-
The removal CU is listed in the Project pane.
-
-
Designer XI locates a probable removal CU, but seeks your input to confirm it found the appropriate one.
-
A green badge
appears on the map alerting you to the
probable match. -
Hover over the green badge, review the recommendation, and press A to accept.
-
Or, in the Project pane, click the Change CU
tool to search for a more appropriate removal CU.
-
-
Designer XI does not have enough information to automatically assign the removal CU and requests you search in the catalog for it.
-
A red badge
appears on the map alerting you that no
match was found. -
Hover over the red badge and press C to search for the CU manually.
TIP: If there are multiple red badges in the same location, they stack on top of each other. After you clear a badge, hover over the stack again to address the next issue.
-
-