Setting up disturbance alarms using display
You can use the display to configure the disturbance alarms.
- Navigate to .
- Enter the setup passcode (default is “0”),then press OK.
- Navigate to .
- Move the cursor to point to Sag Alarm or Swell Alarm you want to modify, then press Edit.
- Modify the parameters as required, then press OK.
- Press the up arrow to exit. Press Yes to save your changes.
Sag alarm/Swell alarm setup parameters available using the display
Parameter
Values
Description
Enable
Yes, No
This enables or disables the alarm
Priority
High, Medium, Low, None
This sets the alarm priority and notification options
Select Dig Output
None
Digital Output D1
Digital Output D2
Digital Output D1 & D2
Select the digital output(s) you want to control when the alarm is triggered