Removing the PM5563 from the DIN rail
Installation, wiring, testing and service must be performed in accordance with all local and national electrical codes.
![]() |
---|
HAZARD OF ELECTRIC SHOCK, EXPLOSION,
OR ARC FLASH
Failure to follow these instructions will result in death or serious injury.
|
- Turn off all power supplying this device and the equipment in which it is installed before working on it.
- Always use a properly rated voltage sensing device to confirm that all power is off.
- Insert a flat-tip screwdriver into the DIN release clip.
Pull down the clip until you hear an audible click and the DIN clip
is unlocked.
- Swing the meter out and upwards to remove the meter.