HRB1684301-11

Temporarily disabled configuration settings and login requirements in webpages

The configuration settings in the webpages for the meter models and their firmware versions (x = number) shown in table are temporarily disabled to meet latest cybersecurity best practices and these will be restored in the future firmware release.

NOTE:
  • For the meter models with the firmware versions shown in the table, the HTTP and FTP services are accessible without user credentials. To access FTP service, navigate to Maint > Setup > Comm > Enet and set the parameter to Enabled on the meter’s HMI display.

  • Use the ION Setup configuration tool (version v3.2.20127.03 and later) or the meter’s HMI display to overcome some of the function / feature limitations.

Meter models

Firmware version

PM5560

v2.7.8

PM5563

v2.7.8

PM5650

v2.10.1

PM5570

v3.1.x

PM5580

v2.7.8

PM5660 / PM5760

v3.1.x

NOTE: The firmware version files mentioned in the table are not published on the Schneider Electric website due to compliance reasons. If you already have a meter with these firmware versions and need the same firmware version files for any reason, contact Schneider Electric Technical Support.

PM5560 / PM5563 meter models and its limitations

Function / Feature

v2.7.7 and earlier

v2.7.8

ION Setup
v3.2.2.127.03 and later

HMI display

Webpages

HMI display

Webpages

Ethernet configuration (basic with port setting)

ü ü ü ü

HTTP Enable/Disable

ü ü ü ü

FTP Enable/Disable
(Auto-disables if idle for 20 minutes)

ü ü ü

Serial port settings

ü ü ü ü

Advanced serial port settings

ü ü

BACnet/IP configuration

ü ü ü ü

DPWS Enable/Disable

ü ü ü ü

EtherNet/IP Enable/Disable

ü ü ü ü

DNP3 Enable/Disable

ü ü ü ü

PM5RD remote display configuration
(Only PM5563 meter model)

ü ü

Device log export

ü

Advanced Ethernet configuration

ü

SNMP configuration

ü

Modbus TCP filtering

ü

Network Time Synchronization (NTP) configuration

ü

SMTP configuration

ü

Web user account settings

ü

PM5570 / PM5580 / PM5650 / PM5660 / PM5760 meter models and its limitations

 

HMI display

Webpages

ION Setup
v3.2.2.127.03 and later

Ethernet configuration (basic with port setting)

ü ü

HTTP Enable/Disable

ü ü

FTP Enable/Disable
(Auto-disables if idle for 20 minutes)

ü ü

Serial port settings

ü ü

Advanced serial port settings

ü

BACnet/IP configuration

ü ü

DPWS Enable/Disable

ü ü

EtherNet/IP Enable/Disable

ü ü

DNP3 Enable/Disable

ü ü

Device log export

Advanced Ethernet configuration

SNMP configuration

Modbus TCP filtering

Network Time Synchronization (NTP) configuration

SMTP configuration

Web user account settings

NOTE:
  • For Device log export, use EcoStruxure™ Power Monitoring Expert (PME) or EcoStruxure™ Power SCADA Operation (PSO) or any other third-party software to configure and capture the information from meter and save into a log.

  • For SMTP configuration or Email on alarm settings, use EcoStruxure™ Power Monitoring Expert (PME) or any other third-party software to perform configuration.

QR code for this page

Was this helpful?