HRB1684301-11

Monitoring waveform capture on meter’s webpages

NOTE: Refer to Temporarily disabled configuration settings and login requirements in webpages to know applicability of these features on your meter model.

Before you can view waveforms on the meter’s webpages, you need to perform some basic configuration using ION Setup to enable waveform capture and store the waveforms in COMTRADE format.

Manual trigger

1. Enable waveform capture on your meter

Set the status to Enable using ION Setup .

2. A waveform is captured when it is manually triggered using Modbus command or ION Setup

A COMTRADE record is generated and saved to your meter’s FTP site.

3. View the waveform on the meter’s webpages

Launch a browser and go to the IP address for your meter, enter valid login credentials when requested.

Navigate to Monitoring > Waveforms to explore the waveform data.

Automatic trigger

1. Enable waveform capture on your meter

Set the meter’s nominal voltage and sag/swell parameters using ION Setup .

2. A waveform is captured when a power quality event occurs

A COMTRADE record is generated and saved to your meter’s FTP site.

3. View the waveform on the meter’s webpages

Launch a browser and go to the IP address for your meter, enter valid login credentials when requested.

Navigate to Monitoring > Waveforms to explore the waveform data.

QR code for this page

Was this helpful?